Jump to content


Recommended Posts

I am encountering an issue with a Surface Book.

The device PXE boots fine, and it pops a message like it's going to start and prompt me for the password. Then, it never pops up, and just reboots.

any suggestions?

the drivers are distributed, and in my task sequence. 

Share this post


Link to post
Share on other sites


It quits at "Preparing Network Connections", however I cannot find any network drivers for the surface ethernet adapter (model 1821). It says they are included with W10 1511 and newer.

But, that doesn't help me with SCCM.

Share this post


Link to post
Share on other sites
51 minutes ago, gavin1973 said:

Hi,

Just to clarify the laptop is able to pxe boot and pull down your boot image but fails before the task sequence starts?

 

Yes. I am using a surface Ethernet adapter model 1821 (Gigabit Ethernet USB 3.0).

it fails when it's trying to prepare network connections.

I have a surface Ethernet adapter model 1663 (gigabit Ethernet USB 3.0) and it allows me to get through the whole process. 

 

Share this post


Link to post
Share on other sites

It very much sounds like nic drivers needed in the boot image which has caused me headaches over the years and have you added the driver pack into SCCM task sequence?

in past experience boot image has been fine but not having the correct drivers in the task sequence let me down. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...