GCITGuy Posted June 21, 2018 Report post Posted June 21, 2018 Hello, I am a newbie to learning SCCM and I am in a new role. I am asking for help to determine what is failing our Windows 10 OSD Task Sequence. This task sequence fails and from what I am thinking, the previous SCCM admin was trying something and created a new boot image that in the end is causing failures. The weird thing is that a PC taken out-of-the-box does not fail to load the OSD Deployment, it is whose desktops and laptops that are re-imaged that fails. The error code that gets displayed is 0x80070490. The SMSTS.log is included attached to the thread. There is a part of the end of the log where the WinPE boot image starts the PXEboot deployment is not the same WinPE boot image that is used to start the Windows 10 OSD deployment. So my question is whether this is what is failing the OSD deployment? Thank you all for help and advice. smsts.log Quote Share this post Link to post Share on other sites More sharing options...
jHetzer Posted June 23, 2018 Report post Posted June 23, 2018 Some shots into the blue according to the logs: No boot image is assigned to the Task Sequence (https://technet.microsoft.com/en-us/library/bb633210.aspx?f=255&MSPPError=-2147217396 Section: Use Boot Image) Disk is not formatted (Legacy / UEFI Layout) Disk driver missing/required To check if the disk driver is missing/required in WinPE try following: Enable Command Prompt: https://blog.thesysadmins.co.uk/sccm-2012-sp1-enable-command-support-console-winpe.html PXE Boot Press F8 to open a command prompt before selecting a task sequence Enter "diskpart", "list disk" and "list volume" If you have outputs the disk is recognized/accessible from WinPE Quote Share this post Link to post Share on other sites More sharing options...
