Jump to content


CindyP750

Failed to run Task Sequence

Recommended Posts

After updating from 5.009040.1000 to 5.009040.1019 I am having problems imaging some endpoints.

errors I get are Failed to run Task Sequence:  0x8007000F, 0x80004005, and 0x80070490.

I also get a screen now that I never got before.  see Attached Ready to Start.  I have looked through your knowledge base but am not getting this figured out.  I am also attaching a screen shot of About Microsoft EndPoint Config Manager.  Any help would be appreciated.

AboutSCCM.JPG

ReadytoStart.jpg

Share this post


Link to post
Share on other sites

if this is a reimage, i would try running disport on the machine. that should get rid of the your error message. open a command prompt and run these commands

Diskpart
Select disk 0
Clean
Convert gpt
Create partition efi size=200
Assign letter=s
Format quick fs=FAT32
Create partition msr size=128
Create partition primary
Assign letter=c
Format quick fs=NTFS
Exit

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.