parko89 0 Posted August 22, 2012 Report post Posted August 22, 2012 I've seen a few blogs which have guides to add Remote Control support to Boot Images which I found would be quite useful. Especially if it's in the Boot Image rather than the Task Sequence so I would be able to RDP/VNC/DameWare etc to the client in WinPE. My main goal is for troubleshooting and for support during the build stage. I've seen the following posts but didn't have too much luck with getting it to work: http://www.deploymentresearch.com/Blog/tabid/62/EntryId/36/Software-Assurance-Pays-Off-Remote-Connection-to-WinPE-during-MDT-SCCM-deployments.aspx http://blog.danovich.com.au/2011/12/27/dameware-remote-control-in-winpe/ http://depsharee.blogspot.com.au/2010/06/integrate-vnc-to-windows-pe.html Anyweb - it would be awesome if you could add a Step-by-Step for this topic as I'm sure a lot of admins would benefit from it. Thanks! Quote Share this post Link to post Share on other sites
Peter van der Woude 143 Posted August 22, 2012 Report post Posted August 22, 2012 See also: http://blogs.technet.com/b/mniehaus/archive/2012/07/31/mdt-2012-update-1-monitoring-for-configmgr.aspx Quote Share this post Link to post Share on other sites
Avi 0 Posted August 26, 2012 Report post Posted August 26, 2012 Hey, May i ask where were you having troubles in that guide? http://www.deploymentresearch.com/Blog/tabid/62/EntryId/36/Software-Assurance-Pays-Off-Remote-Connection-to-WinPE-during-MDT-SCCM-deployments.aspx Because i followed it and it worked for me Quote Share this post Link to post Share on other sites