Deploy Windows 7 Embedded for Wyse Thin clients

[MarcusOL]

I`m looking for a way to install software or run scripts in the task sequence for our Wyse Z90D7 Thin Clients.

 

 

Problem is that nothing runs anymore after the "Setup windows and ConfigMgr" task because of the sysprep scripts in the c:\windows\setup dir.

I`m making a copy action from a software package to the root of the c-drive and than run scripts from the sysprep scripts. But easyer would be to do it in Tasks. Has anyone have an example or tips?

[MarcusOL]

I found a way and it works pretty good. I use the post deployment scripts of SCCM. See this short guide: http://cloudsurvivalguide.com/sccm-2007-run-scripts-wyse-deployment/

[bdazle]

We too are looking to deploy Z90D7 Thin Clients. We done a build and capture and have created a task sequence. We have been successful in deploy it though after a restart the unit gets stuck at a grub boot loader screen, so I was looking for something like this and the link is dead any chance you can put it up again