Skip to content

Failed to run Task Sequence

Featured Replies

After updating from 5.009040.1000 to 5.009040.1019 I am having problems imaging some endpoints.

errors I get are Failed to run Task Sequence:  0x8007000F, 0x80004005, and 0x80070490.

I also get a screen now that I never got before.  see Attached Ready to Start.  I have looked through your knowledge base but am not getting this figured out.  I am also attaching a screen shot of About Microsoft EndPoint Config Manager.  Any help would be appreciated.

AboutSCCM.JPG

ReadytoStart.jpg

the media that your using to boot off of doesnt match the boot file associated with that task sequence. if you update the boot media, that message will go away

if this is a reimage, i would try running disport on the machine. that should get rid of the your error message. open a command prompt and run these commands

Diskpart
Select disk 0
Clean
Convert gpt
Create partition efi size=200
Assign letter=s
Format quick fs=FAT32
Create partition msr size=128
Create partition primary
Assign letter=c
Format quick fs=NTFS
Exit

 

 
  • Author

SCCM will create an UNKNOWN under devices every time I try.  The media I use is created with Rufus and creates a partition.  Not sure how to create new media because I use the ISO created when running the LiteTouch.vbs.  

  • Author

Well I am back to imaging.   Can't thank you enough.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.