The deployment system cannot be started using PXE

[zhangyongcheng]

Dell all
I found that the login time was a little long when loading the PE boot。

Here is the loaded smsts.log, but I really didn't send any error messages.

Hard. Let's take a look

thank~~~

smsts.log

[anyweb]

there's nothing revealed here, it took a couple of minutes to launch WinPE,

search the SMSPXE.log on the primary or pxe enabled dp for the mac address of this device to see when it really started PXE boot.

[zhangyongcheng]

Dear
         SMSPXE.log I checked the log file. No specific problems were found

SMSPXE.log

[anyweb]

no my point was, in order to see WHEN pxe boot started you need to get the timestamp from the smspxe.log

then, compare that with the smsts.log and you can work out exactly how long that device took to boot to the PXE password prompt (if enabled)

[zhangyongcheng]

Dear

I checked the computer to confirm the MAC address,B4:A9:FC:B9:EE:72.

It took 18 minutes to load. I feel like there's something wrong with the timing

Can you tell me exactly where the problem is 

thanks~~~

SMSPXE.log smsts.log

[anyweb]

hi, without more info about this it's hard to tell, has it always been 18 minutes ? is the distribution point hosting the boot image far away from the device you are pxe booting ? or is this only happening on specific models ? more info is needed please

[zhangyongcheng]

Dear

Distribution points and boot devices in a network environment。I tried other device types and the boot time didn't change

Could it be that my boot image package is too big.The boot image package size is 1762.14MB

[anyweb]

i just checked my own x64 boot image and it's 1.8GB so the size is ok,

mine downloads very fast in my lab environment, it could be your switches in the network that are slowing it down

 

[zhangyongcheng]

Thank you for your patience