windows deployment services image capture wizard next greyed out

[P.Bohm 0]

windows deployment services image capture wizard next greyed out

 

I have a Windows server 2012 WDS server with several images on it.

 

Now I made a Capture.WIM with an Windows 8.1 disk, And the installation\preparation on the server seems to work fine. But……..

When I start a capture from the server, the process start normally until I need to contact the server.
It is contacting the server, I need to give the credentials for the Administrator for that server, I can give the Map where to put the capture, but the “Next” button stays “grayed out”.

I tried F10, to get a command prompt so I could make a pad to a Share, but I didn’t get a prompt.

What is happening here?

 

Peter.

 

 

[anyweb 477]

got a valid ip adress in winpe ?

[P.Bohm 0]

Dear Root Admin,

 

Its looks like i had the correct Ip-adress, because ik get the login credentials of the deployment server en may select the map whit de image on\in it.

but there it stops....

 

Peter

[anyweb 477]

did you try pressing left shift and f10 ?

[captcliff1986 0]

I'm having a similar issue here. It started with being unable to get into the Windows Deployment Services Image Capture wizard at all. This is a Windows 7 capture Image I've created with WDS role living inside of a Windows 2012 R2 virtual server. I resolved that portion of the problem with the steps suggested by Saurabh.k and illustrated by Rolf HH at this link (https://social.technet.microsoft.com/Forums/windowsserver/en-US/a164b948-1778-42bd-8d77-9cef1ca70866/image-capture-boot-image-fails-with-0xc000000f?forum=winserversetup) then manually adding the boot image after the DISM mounting/unmounting process. That allowed me to get into the Image Capture Wizard in the first place.

 

After entering, I am able to "connect" to my WDS server, and I can choose an Image Group, but I cannot continue past that point in the wizard because the "next" button is greyed out. I checked and I do have a valid IP address for the subnet, besides that I AM able to connect to the WDS server to at least choose a group. I know this is an old topic, but is the only one I found that seems to illustrate the exact problem I'm having at this time. Anyone able to get past that grey button, or can someone point me at a resource that describes another work around?

 

Does anyone think that MDT 2013 is a better solution than WDS?

 

Thanks,

Cliff

[captcliff1986 0]

So as a followup, I figured out my issue to hitting "next" at that point in the wizard, and it was very simple. It appears you must also have some local device to save that image to, regardless if you are only trying to upload a image to your WDS server. This seems redundant to me, but as soon as I plugged in an external hard-drive to save that wim file to locally, the wizard let me continue. That other link for the DISM mounting/unmounting process I needed to get the Image Capture wizard to start in the first place, so I hope that also helps someone.

 

I'm still having some issues with the image actually uploading to my WDS server which I am still investigating. I will touch base here if I find anything else out, but I may end up just copying the locally stored wim file into my WDS server and importing that as a boot image.

 

Thanks,

Cliff

Edited April 13, 2016 by captcliff1986

[captcliff1986 0]

So my issue with the image not showing up in WDS after being uploaded was resolved by restarting the Windows Deployment Services service. Not sure why that was necessary. In my test captures since then it has worked fine. Just a final update for anyone that may review this.

 

Thanks,

Cliff